tencent cloud

Direct Connect

文档Direct ConnectPractical TutorialIDC Local ConfigurationBGP Routing Configuration GuideCisco C Series Switches

Cisco C Series Switches

下载
聚焦模式
字号
最后更新时间： 2024-11-05 09:46:38
Direct Connect connects Tencent Cloud with the user IDC with a dedicated physical line. After configuring the Direct Connect gateway and dedicated tunnel on the Tencent Cloud side, users need to configure routes on the local IDC. Using the layer-3 sub-interfaces to connect to Tencent Cloud is recommended.
Note:
This document only introduces the local routing configurations associated with Tencent Cloud Direct Connect. For other information, please see the local router documentation or consult your router provider.

Routing Configuration

Note:
It's recommended that you use the default configurations of Keepalive and holdtime for the BGP connection between the two peers. The holdtime is three times the interval at which keepalive messages are sent. The recommended holdtime value is 180s.
# Configure ports
interfaces <interface_number>
description <interface_desc>
no shutdown
no switchport
speed <interface_speed>
duplex full
no negotiation auto
end

# Configure layer 3 sub-interfaces
interface  interface-number.subnumber
description <vlan_description>
encapsulation dot1q <vlanid>
ip address <subinterface_ipaddress> <subinterface_netmask>
bfd interval <value> min_rx <value> multiplier <value> //BFD parameter
end

# Set eBGP 
router bgp <as_number>
bgp router-id <router_id>
neighbor <bgp_peer_address> remote-as <bgp_peer_as_number>
neighbor <bgp_peer_address> password encrypted <bgp_auth_key>
neighbor <bgp_peer_address> description <bgp_peer_desc>
neighbor <bgp_peer_address> activate
neighbor <bgp_peer_address> fall-over bfd single-hop //Configure BFD for BGP
上一篇: Cisco ASR Series Routers下一篇: Cisco Nexus Series Switches

帮助和支持

本页内容是否解决了您的问题？

填写满意度调查问卷，共创更好文档体验。

文档反馈