- Release Notes
- Product Introduction
- Purchase Guide
- Getting Started
- Operation Guide
- Best Practices
- API Documentation
- FAQs
- Announcements
- Troubleshooting
- Contact Us
- Glossary
- Release Notes
- Product Introduction
- Purchase Guide
- Getting Started
- Operation Guide
- Best Practices
- API Documentation
- FAQs
- Announcements
- Troubleshooting
- Contact Us
- Glossary
- Log in to the VPC console.
- Click VPN Connection > VPN Tunnel on the left sidebar to go to the management page.
- Choose a region and VPC (Tokyo and VPC1 in this example) and click +New.
- Enter the tunnel name (e.g. tunnel1). Choose the VPN gateway VPN1 and the customer gateway UserGw1, enter the pre-shared key (e.g. 123456), and click Next.
Note：
Health check is optional and is disabled by default. If it is enabled, please enter the VPN gateway IP address (an available IP not included in the primary CIDR block of the VPC), and the customer gateway IP (an available IP in the IDC IP range).
- On the SPD Policy page, configure both the VPN gateway and customer gateway IP as 0.0.0.0/0, and click Next.
- (Optional) Configure IKE parameters. Click Next if no advanced configuration is required.
- (Optional) Configure IPsec parameters. Click Complete if no configuration is required.
- After the VPN tunnel is successfully created, return to the VPN tunnel list page. Click Moreand choose Download config file to complete the download.
Yes
No
Was this page helpful?