- Release Notes and Announcements
- Product Introduction
- Purchase Guide
- Getting Started
- Operation Guide
- Best Practices
- IPsec VPN
- Hybrid Cloud Primary/Secondary Communication (DC and VPN)
- Connecting IDC to CCN
- Local Gateway Configurations
- Connecting IDC to a Single Tencent Cloud VPC for Primary/Secondary Disaster Recovery
- Establishing a VPN Connection between Tencent Cloud and Azure China
- Establishing Connection Between IDC and Cloud Resources (Dynamic BGP)
- SSL VPN
- IPsec VPN
- API Documentation
- FAQs
- Troubleshooting
- Service Agreement
- Contact Us
- Glossary
- Release Notes and Announcements
- Product Introduction
- Purchase Guide
- Getting Started
- Operation Guide
- Best Practices
- IPsec VPN
- Hybrid Cloud Primary/Secondary Communication (DC and VPN)
- Connecting IDC to CCN
- Local Gateway Configurations
- Connecting IDC to a Single Tencent Cloud VPC for Primary/Secondary Disaster Recovery
- Establishing a VPN Connection between Tencent Cloud and Azure China
- Establishing Connection Between IDC and Cloud Resources (Dynamic BGP)
- SSL VPN
- IPsec VPN
- API Documentation
- FAQs
- Troubleshooting
- Service Agreement
- Contact Us
- Glossary
This document describes how to create a VPN tunnel.
Directions
1. Log in to the VPC console.
2. Select VPN Connections > VPN Tunnel in the left sidebar.
3. Choose the region where your VPC is located and your VPC, i.e. Guangzhou and
TomVPC in this example, and click +New.4. Configure the basic settings of the VPN tunnel.
The basic settings of a VPN tunnel include the tunnel name, region of the gateway, network type, VPN gateway instance, customer gateway instance, pre-shared key, negotiation type, and communication mode. For more information about the parameters, see Creating a VPN Tunnel.
In this example, the communication mode is SPD policy, the local IP range is the IP range
192.168.1.0/24 of subnet A, and the customer IP range is 10.0.1.0/24.5. Configure the advanced settings.
In this step, you can set the advanced parameters, including DPD, health check, IKE, and IPsec. In this example, the default parameter values are used.
Note:
Make sure that the settings of IKE and IPsec on the cloud side are the same as those on the local side. Otherwise, the tunnel fails due to inconsistent protocol configurations.
6. Check your configuration and click Create. After the tunnel is created, go to the VPN tunnel list page, click More next to the created tunnel, and choose Download config file to complete the download.
はい
いいえ
この記事はお役に立ちましたか？