Setting Security Protection for Collaborators

Last updated: 2020-05-15 10:55:52

    Introduction

    This document describes how to enable and disable security protection for collaborators. This will determine whether collaborators need to go through security authentication.

    Directions

    Enabling security protection for collaborators

    1. Log in to the CAM Console and select User > User List on the left sidebar.
    2. On the User List management page, select the collaborator for whom to configure security protection.
    3. Click the user name to go to User Details.
    4. On the User Details page, click Security to go to the security management section.
    5. Click Manage next to Identity Security. See the figure below for reference:
    6. In the Identity Security window that pops up, select the protection type you want to enable for the collaborator.
    7. Click OK to enable security protection for the collaborator.

      If virtual MFA device verification is enabled, the collaborator will need to bind the MFA device as prompted the next time they log in.

    Disabling security protection for collaborators

    1. Log in to the CAM Console and select User > User List on the left sidebar.
    2. On the User List management page, select the collaborator for whom to configure security protection.
    3. Click the user name to go to User Details.
    4. On the User Details page, click Security to go to the security management section.
    5. Click Manage next to Identity Security. See the figure below for reference:
    6. In the Identity Security window that pops up, select the protection type you want to disable for the collaborator.
    7. Click OK to disable security protection for the collaborator.

    Was this page helpful?

    Was this page helpful?

    • Not at all
    • Not very helpful
    • Somewhat helpful
    • Very helpful
    • Extremely helpful
    Send Feedback
    Help